Houser Racing Long Travel A-arms
Long Travel A-Arms
Ball joints have 1/3 more travel than stock or typical after market ball joints. Note that using this longer travel ball joint allows us to offer after market A-Arms to be made in standard widths for the cross country riders.
Two shock absorber mountings are available.
19 3/8" long, typically used with ProTrax® front end.
16 3/8" long, standard length for Honda 400EX or 250R.
The lower ball joint is sealed. A stainless steel disk seals the bottom side while a rubber boot seals the top. A grease zirk is standard.
The upper ball joint uses a Teflon liner which does not require lubrication. This will provide longer life on an unsealed ball joint.
Grease zirks are provided for A-Arm frame bearings.
Ball joints are replaceable.
All components are made from chromoly steel and are TIG welded.
TT sway bar mount is an option. This is located straight in line with shock absorber to provide the truest force distribution.
Brake line mounting is standard.
Sizes:
Honda 400EX (+3", +0"), (+2", +0"), (+1", +.5"), (+0",+0)
Honda 250R (+3", +1"), (+2", +1"), (+1",+1"), (+0",+1")
Cannondale (+2", +0"), (+2", +1")
Other sizes will be available as requested
$800 Standard Unit
+$75 Top A-Arms chromed
+$35 TT Sway Bar Mounting Brackets
Standard Colors are Hammertone Gray, Black Silvervein, Gloss Red
|